US Bumper Lower Air Intake Duct Set For VW MK3 Golf Jetta
Problem Solved
Original MK3 lower bumper blanking panels give the front bumper a closed and plain appearance. This replacement duct set opens up the lower side sections with a sportier air intake look while keeping a clean factory-style fit.
- Creates a more aggressive front bumper appearance.
- Replaces the lower side grille hollow covers.
- Adds an intake-style visual upgrade without changing the full bumper.
Fitment
| Make | VW |
| Models | MK3 Golf / Jetta |
| Bumper Type | US-spec front bumper only |
| Not For | Euro-spec bumper / Vento MK3 bumper |
| Notes | Please compare your bumper type with the product photos before ordering. |
Installation
- Remove the original lower bumper side covers / blanking sections.
- Trim the bumper inner tabs as shown in the product photos.
- Test fit both left and right ducts before final mounting.
- Screw mounting to the upper section of the bumper is required.
- Check alignment before fully tightening all fixing points.
FAQ
Is this for US bumper or Euro bumper?
This version is for US-spec MK3 Golf / Jetta bumper only.
Will this fit Euro bumper Golf or Vento?
No. This listing does not fit Euro bumper Golf MK3 or Vento MK3 bumper.
Are screws included?
No. Screws are not included.
Important Notice
Minor modification is required; this is not a completely clip-on installation. Please confirm your bumper type before ordering. No paintwork service is included. Installation screws are not included.